Hanging Lights From Ceiling Tiles. Hanging light installation into a ceiling tiles about press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new. Measure from all sides to find the exact center of the tile and trace the outline of the light in this spot.
For each ceiling tile where a light will be located, remove the tile and place it on a work surface. 12 drop ceiling hooks for classrooms & offices, white…. Put the ceiling tile back in its place and trim any unnecessary unevenness.
Remove the backing from the hook and press it onto the ceiling for 30 seconds until it’s secure. Place hooks around the edge of your ceiling every 2 ft (61 cm). This way the weight is carryed by the supporting frame, rather than by the tile.
Snap a chalk line marking the top of the wall angle. Mounted lights are not supported by the suspended ceiling but by the existing ceiling beneath. As each row of ceiling tiles is put into place, finish the installation by snapping the runners into the top hangers as shown below.
Install full ceiling tiles in the remaining rows by rocking the cross tee and placing each tile in the grid system. Round ceiling fitting cf546 sm satin. Run the electrical cables between the holes in the ceiling tiles.
The last time i hung lights from a suspended ceiling, i just cut some wood 3/4 inch by 1.5 inchs that was exactily the same width as the ceiling tile, ( in my case 24 inchs ) i laid this across the back of the tile, and put an eye bolt thru the tile and into the wood. Measure from all sides to find the exact center of the tile and trace the outline of the light in this spot. The light switch on the wall turns on/off the power these receptacles.
The runner is 8′ long and snaps into the top hanger, locking the grid system and ceiling tiles. Put the ceiling tile back in its place and trim any unnecessary unevenness. Hang the chain from the hook or wrap the wire around the screws and tighten the screws.
Comments
Post a Comment